FPV monitor & battery box
Description
The objective was to make a container to organize & contain an FPV receiver, LCD monitor, switched battery, voltage converter and all associated cables for easy transport and use. Versions for 5" and 7" LCD displays were produced. Both versions make use of pairs of 10mm x 2mm round magnets to retain the lid/back of the container. The magnets are CA glued to mounting blocks which, in turn, are CA glued to the box framework and the back/lid. The magnets used were similar to these: https://www.amazon.com/gp/product/B08156543C The 5" LCD used was this one: https://www.amazon.com/gp/product/B072FNQQXV The 7" LDC used was this one: https://www.amazon.com/gp/product/B06X1BKZVC This display came with a bezel for "in-dash" installation. I built the box around it, recessing the display in the box required a deeper box than with the 5" box which used surface mounting. Both boxes make use of an XL-6019 circuit to boost 2S battery output to 13.5v for both the LCD and the FPV receiver's use. The circuit board I used was this one: https://www.amazon.com/gp/product/B082XQC2DS A small 2 part box was printed to house the circuit board. A simple 12v DC switch provides for on/off switching of battery input. I used switches like these: https://www.amazon.com/gp/product/B07T1JG6BD They include a pilot light, which is not necessary but was simple to implement.
Statistics
Likes
0
Downloads
0