insta360 one r 4k mod fpv drone holder
Description
Print with 0.6 nozzle(0,4 nozzle takes it to long to print, but on this model I added some texture to remove visible layers) with supports under hinge. I did not left any holes because its really hard to get perfect finish with tpu on supports, so I just left only 1 perimeter walls where the holes should be. It's not a problem to make some cuts with hobby knife for the holes. Also you need make 4 cuts to push the camera in. Don't try to print it with TPE because you'll have jello. Place this case on the table with the
Statistics
Likes
5
Downloads
0