Resin bottle strainer stand
Description
Quickly replace unused resin back into the bottle using this strainer stand that attaches itself using a simple rubber band. Just ensure the strainer is centered when you pour and you use a fine strainer otherwise the resin will run straight through outside the bottle mouth. Pictured is using the strainers that came with an Elegoo printer. Works on most 1000g and 500g bottles. I show a few different bottle types. I've used it about a dozen times now, here are some usage tips. - if your strainers are flat and stiff, just put a few creases to bring it back to a cone. - start slow until all the screen mesh is filled, then you can fill it up. Otherwise you may get some drips larger than the bottle mouth. Once the mesh gets coated, surface tension makes one single stream coming off the point. - put the stand on the bottle before opening the cap ( just move it to the side while unscrewing). That way the rubber band doesn't contact any resin. ** Printing Easiest and fastest method is using an FDM printer. I printed it with my Elegoo Mars 2 Pro standing the parts upright with supports. For the legs, I added extra supports under the point closest to the plate because it can break off.
Statistics
Likes
96
Downloads
0