er25 collet holder for Kennedy case toolbox
Description
This fits 15 er25 collets in the upper position and 20 in the lower. Perfect for a set of metric and standard. Tested to fit in the top of both the 26" and 20" width Kennedy case. It's pretty flimsy, so you don't want to be moving it around when it's loaded with collets. Meant for use being kept at all times in the toolbox. I had to trim the cut-out / notch where the drawer cover locking pin is because it was too tight. I'll probably revise this to make it a little more sturdy. Took around 6 hours to print for me. First time using the hatchbox pink, I wish it was a little brighter.
Statistics
Likes
3
Downloads
0