Slim Frog Case A and B with inserts
Description
I remixed this from : https://www.thingiverse.com/thing:4094861 and https://www.thingiverse.com/thing:4727941 The included enclosures are remixed from: https://www.thingiverse.com/thing:4640334. The closures were modified slightly (as they bumped the seam on this box and I found a few weak points when mounting. I also extended the 'hook' end so that it locks more securely. All the hinges and clasps use m3x20 screws, with the exception of the 'hinge' pin in the middle of the closure. I used a piece of scrap filament for this. I used the bit holder version of the box for the base for the tri-hinge version, so it has a flatter bottom internally, while the top is concaved somewhat. I have included the bit holder that I used to fill the small bit holder version, as well as the full bit holder case. I had a lot of fitment issues with his bit holder, and as it has a lid I did not need a pressure fit for my bits. The bit holder insert is about .1 to .2 mm too large for the opening so it will probably need a bit of finishing to fit, but this allows a very snug fit and no adhesive. The long version is only modified to be shallower, so if you need more depth please refer to the original. I have included insert versions of the lids for everything except the bit holder version, and both blank inserts and an example one (a variant on a red cross that appeared in The Expanse) for both of the insert sizes.
Statistics
Likes
2
Downloads
0