MPCNC Primo AMB/kress FME800/1050/1400 mount (Original holes)
Description
MPCNC Primo (25mm tube) mount for all AMB/Kress mills, except the one with quick change. This mount is designed to use the original Primo Z-rails holes of 75mm apart (https://docs.v1engineering.com/mpcnc/PZPage/). This design is also compatible with HEX socket head bolts instead of the normal flat HEX bolts and uses (mostly) the same bolts/nuts as the Primo version. In the pictures a AMB (kress) 1050 FME-P is used. Needed: 4x M5x16 HEX socket bolts (M5x25 is maximum) 3x M5x30 Round head bolts (used in the Primo version) (M5x25 is minimum) 7x M5 Locknut (used in the Primo version) 2x Nut_trap_Primo_STL (https://www.thingiverse.com/thing:4550789/files) 1x LowerMount (see ‘Thing files’) 1x Uppermount_back (see ‘Thing files’) 1x Uppermount_front (see ‘Thing files’) Installation instructions: 1. Drill the z-rail holes in the tube and insert the Nut_trap_Primo_STL together with 4x M5 locknuts into the tube. Make sure the locknuts have a tight fit or else they will fall out! 2. Mount the LowerMount using 2x M5x16 Hex socket bolts and tighten them. The short side of an Allen key is used combined with the maximum force you can apply to ensure the right fit, no more force is needed. 3. Mount the Uppermount_back using 2x M5x16 Hex socket bolts and tighten them using the technique described above. 4. Insert 2x M5 locknuts inside of the Uppermount_back. 5. Place the AMB/kress mill in the LowerMount, as shown in the pictures. 6. Mount the Uppermount_front over the AMB/kress mill and use 2x M5x30 Round head bolts to fix it to the Uppermount_back. The gap between these parts is 4mm and there is no need to close this, fixed is fixed! 7. Place a M5x30 Round head bolt and a M5 locknut in the LowerMount and tighten them until the mill sits tight. The gap here shouldn’t be closed either! Compatible with: AMB (kress) 800 FME (USA version) AMB (kress) 800 FME AMB (kress) 800 FME-Q AMB (kress) 1050 FME-1 AMB (kress) 1050 FME-P AMB (kress) 1050 FME-P DI Digital interface AMB (kress) 1400 FME-P AMB (kress) 1400 FME-P DI Digital interface Not compatible with: AMB (kress) 1050 FME-U Di Quick-Change with digital interface
Statistics
Likes
5
Downloads
0