Sink Utensil Holder
Description
Utensil holder for doing dishes. There's an incline on the inside so that water doesn't sit at the bottom. Water should flow forward and fall into the sink; although if you test it with a faucet like I did, you might get some flow out of the sides since the side pattern is cut low (but this isn't the typical use case lolz) Material: PETG Infill: 15% Layer Height: .25mm; I set the bottom layers to 6 to make it more dense at the bottom, but probably doesn't make much of a difference. Supports: No
Statistics
Likes
16
Downloads
0