Raspberry Pi 3 B+ case w/ cam arm for ender 3/CR6 SE/CR10
Description
Raspberry pi 3B+ case with built in camera attachment for my CR6-SE also should be compatible with the ender 3 There's a million octoprint set-ups out there but I wanted something that took advantage of the z space available on the cr6-se This is a remix of 4 separate things: (some heavily modified) pi cam arm https://www.thingiverse.com/thing:4713656 pi 3B+ case https://www.thingiverse.com/thing:1956623 swivel https://www.thingiverse.com/thing:1774927 ender attachment https://www.thingiverse.com/thing:3126366 materials needed: -super glue -M3 screws and nuts, longer than ~25mm -PLA print 1 of each part, two of the camera mount if you want a 3 piece set up like pictured. Place swivel interior inside swivel exterior. Dab superglue on the tabs of the swivel exterior, careful not to use too much or get it on the interior piece. Press on to top of case in desired spot (I used rear left, by the power indicator LED). Dab glue unto bottom of "Clip" (arm attachment) and press onto top of swivel.
Statistics
Likes
1
Downloads
0