FOR Gaugemaster 16v/12v board adapter
Description
FOR Gaugemaster 16v/12v board adapter I purchased a Gaugemaster power supply that has 16v AC and 12v DC outputs (Gaugemaster Product Code: WM1 - (GMC-WM1). It works well. The unit employs a small PCB that adapts the output from the transformer to the required twin voltage outputs. This too works well but I wanted to fix the PCB down so that it would be easy to connect and disconnect the cable from the transformer. I designed this little block to hold the PCB. The PCB slides into the block from the back. It’s a tight fit to keep it in place. My PCB fits perfectly. The slot is made to allow clearance for the components at the edge of the board. The output wires turn back through the two holes, under the board and out through the back. I am using this item and it has been very successful so far. There is no top or back on the block to allow for dissipation of heat. It also allows the LED to be visible. I really hope someone will find this useful. DISCLAIMERS 1. This item is not endorsed or approved of by Gaugemaster. 2. This item was designed for my own use. I cannot be sure that it will not damage the PCB in some way. 3. I am sharing this item freely as it might be useful to someone. I will not take responsibility for damage, errors or anything else that goes wrong resulting from printing or using my design. Please use your common sense, check clearances, wiring, etc.
Statistics
Likes
5
Downloads
0