Ghost qT antenna vertical mount
Description
A folding TPU holder for the ImmersionRC Ghost qT so it mounts vertically on a 5mm standoff post, the mount hole is actually 4.8mm to help it grip the post better. It includes a pulltab so you can unclip it much easier. Best to put the TPU mount on the standoff first, then install the antenna, since the tab could get stuck if you put the mount on the standoff with the antenna already in. NOTE: Be careful when pulling the tab to unclip the holder to not damage the wire, since this was not designed to be clipped and unclipped repeatedly. EDIT: STL has been updated. The original single-pulltab design would bend the antenna coax wire too much when unclipping the holder, so I added a 2nd pulltab, enabling you to pull the holder apart by pulling on the tabs simultaneously. Please re-download if you read this. Print in TPU, 0.2mm layer height, 4 perimeters, no support. Direct download link from my website: http://www.haku.co.uk/3D/Ghost_Antenna_Vertical_5mm_Standoff_Mount.stl You can sell prints of this, but don't overcharge, you didn't pay for this design, and link back here. You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Statistics
Likes
13
Downloads
0