Blue Yeti fully 3D printable pop filter
Description
A pop filter is a must have for any microphone. I wanted one not just to be functional but to also look nice and be completely 3D printable. For the filter in front of the mic i sliced without the bottom and top layer with 30% rectilinear infill to create this very functional part. My advice is to make the first layer 0.16 height, 0.4 width so it will stick to the plate and the second 0.24, 0.4 so it will not drag the delicate fibers from below. Also if you have problems crank the flow multiplier to 1.1 ;) and go slow (25mm/s) If you give this a try share the picture and let us know if you can do even better by remixing this. Have fun!
Statistics
Likes
18
Downloads
0