Enclosure base for HyperPixel 4.0 Square Non-Touch and raspberry pi zero
Description
Support me: <a href="https://www.buymeacoffee.com/printminion" target="_blank"><img src="https://bmc-cdn.nyc3.digitaloceanspaces.com/BMC-button-images/custom_images/orange_img.png" alt="Buy Me A Coffee" ></a> One color Enclosure for pimoroni HyperPixel 4.0 Square Non-Touch* (720x720 pixels (~254 PPI)) and raspberry pi zero. * it will not fit with HyperPixel 4.0 Square Touch Cover may find here https://cults3d.com/en/3d-model/gadget/enclosure-base-for-hyperpixel-4-0-square-non-touch-and-raspberry-pi-zero You can order it on shapeways (without logo): - [Enclosure and Cover in same color](https://bit.ly/2PS74SU) - [Enclosure base](https://bit.ly/3evakxY) - [Enclosure Cover](https://bit.ly/3lh5Yfk) Check out videos: * Assembly https://youtu.be/kvvdSguD19g * Disassembly https://youtu.be/set75_ZADRM You will need a small peace of foam in order to keep display in place. I used the [tesa powerbond](https://cutt.ly/2zGxxra) (remove protective film only from one side). **WARNING: WHEN INSTALLING HYPERPIXEL 4.0 SQUARE ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.**
Statistics
Likes
19
Downloads
0