Probe Holder Base for RTB2000 Rohde & Schwarz Oscilloscope
Description
This probe holder base can be attached to a RTB2000 case. It uses air ventilation holes to snap in. This part is the base for different upper parts I plan to create. The first upper part is a probe holder for RT-ZP03 or similar, see link below. I added an stl file with included printing supports (brim). Please use this file for printing. Do not add any brim, rift or wall. The including brim is easy to remove. Printing • optimized for 0.4mm nozzle and 0.2mm layer • 100% filling • PLA filament Mounting • set the hocks into two air ventilation holes • press the holder down, the two springs are bent (see picture) • move the holder downwards until the springs snaps in • done Unfortunately the right hand side of oscilloscope case is 0.2mm thicker than the left hand side. Links to exists probe holders • Probe holder for RT-ZP03 or similar → https://www.thingiverse.com/thing:4777568 Planed probe holders • RT-ZP05 (smaller probe) or similar • RT-ZL03 (logic probe) • universal holder Stay tuned! The probe holder can also used for RTM3000 and RTA4000. Supported oscilloscopes (only Rohde & Schwarz): • RTB2002 • RTB2004 • RTM3002 • RTM3004 • RTA4004 CAUTION! This probe holder is covering up to seven air ventilation holes of the device. This affects the cooling of the device! Insufficient cooling can lead to the destruction of the device! USING OF OWN RISK!
Statistics
Likes
0
Downloads
0