MSI RTX 3080 / 3090 VENTUS Dual 120mm Fan Heatsink Adapter / Mount
Description
Use these adapters to replace the existing fans and fan shroud with a couple of quiet 120mm fans (high static pressure optimised fans); you'll also need a couple of GPU to PWM adapter cables and a few twisty cable ties. These are the parts I'm using on my 3090: 2 x Noctua NF-A12x25 PWM 120mm Fan 2 x EK 69734 PWM Cable GPU Print both adapters in ABS (highly recommended - PLA's melting point is too low); each adapter takes under an hour to print at 0.30mm layer height and will fit comfortably on a printer with a 15x15cm build area. Remove the six screws holding the stock fan shroud; re-use these screws to install the adapters. Use a few twisty cable wires to hold each 120mm fan in place. A couple of extra wires can be used to provide extra support where required.
Statistics
Likes
12
Downloads
0