Raspberry Pi 3 B+ Case with Mounting Points for Snapmaker 2.0 OctoPrint Setup
Description
A simple Press-Fit Case for a RaspberryPi3B+ (And all Raspberrys with the same size) With a Mounting-Point for the Z-Axis of the Snapmaker 2.0 A350 (Can fit other Snapmaker Models too) No Venting-Holes (To keep Dirt out of the case when operating the CNC) so watch your Temps. Works fine for me with OctoPrint running. I got a cooler installed from a previous project but don't think its necessary. ( https://www.amazon.de/dp/B07JGNF5F8 ) I used a short Cable to connect the RaspberryPi to the Snapmaker ( https://www.amazon.de/dp/B07DCCL98Q ) I got Low Voltage warnings using OctoPrint with normal USB-Adapters... I Bought a new one and now it works fine: ( https://www.amazon.de/dp/B01AFX29OQ ) The Hole for the USB-Power is a bit of a tight fit, but it works.
Statistics
Likes
7
Downloads
0