Amazon Voice/FireTV Remote w/Tile Pro
Description
This is a remix from https://www.thingiverse.com/thing:4085406 with following changes: 1. Support for Tile Pro instead of Tile Sticker or Tile Mate. I cut out slots on the sides to insert the Tile Pro. It was a snug fit and doesn't come out unless you apply enough pressure to push it out (but it will come out so that you can replace the battery as needed). As the Tile Pro was the same width as the remote, I left both sides open. Originally I was thinking to make the holder wider, but it would have been too wide to hold comfortably.... so I left the width and just opened the sides. 2. I re-centered the hole in the front to allow you to press the button. 3. I created a new hole in the back so that the speaker from the Tile wasn't muffled. 4. The fireTV remote was very tight on the original version. Someone posted a comment that they increased the size by 2% and it fit the remote better. The version of the STL that I printed and posted here has the 2% increased X & Y axis (not Z axis) so that the remote slides easily on and off. I also left a small cut away between the remote and tile compartments thinking that you may need the hole to push the remote out of the holder, but in practice I found that the remote slides out easily with the 2% increase and X & Y and therefore that hole was not necessary but I left it in as it was hidden anyway. 5. Not intentional, but the method I used to redesign the bottom part of the remote left the remote slightly smaller on the bottom and it gets wider as the Z axis increases. This ended up being a feature that I kept as it was more comfortable to hold in my hands. The top part holding the FireTV Remote is identical from the original version that I remixed. I printed without supports standing straight up. I thought I was going to need supports for the section between the firetv remote and tile holder, but in the end it printed fine without the supports.
Statistics
Likes
6
Downloads
0