No-Tie Shoe Laces (Secure Hold!)
Description
So, this isn't exactly some super innovative concept BUT if you are one of those people who aren't exactly fans of tying shoelaces, have a 3D printer (or access to one), and have some TPU filament...This thing is for you! My major focus while designing these was to make sure that once inserted, *the laces remained securely in place*. I found that other designs slipped out too easily. With these laces, the ends are slightly thicker, and have "hooks" for a sturdier hold. Personally, the one time I did try to remove one, I ended up having to cut off the ends because I couldn't slip them out through the eye-holes. I have uploaded STL files with the following lengths: * 40mm * 45mm * 50mm * 55mm * 60mm * 65mm * 70mm To figure out what size you need, put on a shoe and measure the distance from one eye-hole to the opposite eye-hole. If you notice that not all the eye-holes are roughly the same distance apart, you might need to mix-and-match multiple sizes. For reference, I wear a US men's 9 and I used 45mm laces for all eye-hole pairs.
Statistics
Likes
18
Downloads
0