Ortur laser master 2 dragchain mounts
Description
I didn't find any ortur laser master 2 drag chain mounts i liked so i decided to make my own. I think this should work with any dragchain with a width thats roughly between 25 to 30 mm that you can mount using M3 screws and nuts. The one i used is 30mm wide. -I used 15x15mm angled aluminum for the guide rails. Smaller should be fine too. -Use M3 nuts and bolts to mount the dragchains, and guiderail clamps. -Use M4 bolts and self locking M4 v-slot nuts to mount the Y axis dragchain mounts. -Clamp X axis Dragchain guide mount - Left between the acrylic and the stepper motor. -Use the acorn nuts on the oposite sides to mount X axis Dragchain guide mount - Right. -The stepper motor mounts clamp in the middle of the stepper motors. (optional: Use zipties to secure them and keep them from bending long term) Print one of each, except the dragchain guide clamp, you'll need two of those. I know it's a confusing mess, but i hope everything is clear! Show me your builds if you decide to use my design!
Statistics
Likes
80
Downloads
0