Hitec Servo Horn for T3
Description
Revised to replace stock servo horn for the Team Associated T3. This should work for other applications. The length center to center is 15.5mm. There are two versions one without added bracing and one with. These are fairly stout so both are quite stiff. I printed these without supports and other than a little loose extrusion in the screw countersink there were no issues. You may want to use a brim for adhesion since these are small parts. The hole for the ball-stud will likely need to be reamed a bit to start threads. I ran a tap through and everything fit up fine.
Statistics
Likes
2
Downloads
0