Ender Holders
Description
was searching all over for correct holders to accommodate my tools. decided to just go ahead and make some. makes the work station very clean with a spot for everything. this is my first uploaded thingy so any feedback is appreciated! file 1: Flush Cutter Rail Holder (picture 6) file 2: 40g Elmers Glue Stick Rail Holder (picture 3) file 3: Small Elmers glue stick Rail Holder (picture 4) file 4: 20g Gorilla Glue Rail Holder (picture 2) file 5: X-Acto Knife Rail Holder (picture not shown) (sorry but the STL file was deleted and I cannot recover it *The GCODE File still works (set up under ender 3 Printer using PLA+) file 6: Bic Lighter Rail Holder (picture 5) file 7: Bed Clip Rail Holder (picture 7) I have provided the .GCode files that are ready to print in the correct orientation needed with supports. also included the .STL I used PLA+ as that's what I tend to use for everything. (heat settings 215* TIP - BED 60* Then Turned down to 50* after fan ramps up to 100%)
Statistics
Likes
7
Downloads
0