The Ulitimate lens cap for DJI HD Camera (Ø14mm), or any Ø15, Ø14, or Ø12mm FPV camera lens, with Pull Tab
Description
These lens caps fit any Ø15, Ø14, or Ø12mm FPV camera lens. The DJI HD camera has a Ø14mm lens. The FPV camera is usually a little recessed in the typical quad and it can be hard to get your fingers on the cap to remove it with some quads. Also, when you have your xmtr in one hand, the 4-copter in the other and realize the lens cap is still on !!! So I added a little pull tab to make it easier to remove it. The stl is sized for TPU shrink and it goes on easy but comes off a little hard (as desired) - hence the pulltab. To keep the cap surface from touching the lens, the inside roof is domed and also has a spacing ring. There is an 0.86mm wall version for extra tight camera openings, and a 1.5mm wall versions if you want it to be extra durable. The Ø15 and Ø12mm versions are 0.86mm walls I print it with the tab down with supports on the build plate only so that the inside surface of the cap, that faces the lens, is clean and smooth. TPU supports that only touch the bottom side of a surface are easy to remove, so this works out well.
Statistics
Likes
0
Downloads
0