2.5'' Stackable SSD/HDD Holder
Description
This is a stackable 2.5'' holder. 1. Print the parts out obviously. (REQUIRES SUPPORT) (for infill idk, I think 10%, 20% should be good, but not sure). 2. Glue together the two parts on the left/right side, like a U shape. * I don't think glue is necessary here, because of gravity, but it is a preferable choice. 3. Glue the vertical part that holds the U shape together on each of the two holders. * Again I don't think it is necessary but preferable. 4. Add the horizontal part between the two holders. * Again I don't think it is necessary but preferable. 5. Mount your drive on the plate. *The design includes the plate, because I think it is cool to just take the drive with you anywhere else (make it more portable) and not have to unscrew four screws every time you want to take it with you. 6. Slide your drive attached to the plate in the holders and you are done! ONLY A PROTOTYPE! NOT TESTED! unfortunately, I don't have a 3D printer yet :( If you like the design, please leave a like. Since I am into 3D modeling for a week, it would be helpful to find out, if the designs are even good. Check out my other designs!
Statistics
Likes
1
Downloads
0