UNO Card Holder
Description
UNO Playing card holder. I have added in my families name, I have left this off the .stls for obvious reasons. I have added both Text and Non-text versions on the lid and magnet and non magnet version of the base. Magnets - these were just cheap 5x10x1mm magnets glued in. Text - The 'UNO' text has a 0.05mm offset applied so you can print the text separate to the box and then push fit in. The ways some deburring required on the edges as it is a tight fit and may depend on your printer. Supports - I applied supports to the Box just for the spigots for the lid. Infill - 50% I did a high infill to stop the kids from destroying it too quickly but its pretty sturdy so anywhere above 15% should be good. This fits a standard deck of UNO cards but I think if you wanted to adjust for a standard deck of cards it wouldn't be too difficult. I printed this at 0.12 because i wanted it to have a nice finish. I printed the lid face down, to save filament but also to get the smooth finish from my glass bed. I think it came out great. Happy printing. Let me know how you get on.
Statistics
Likes
50
Downloads
0