Wobble Top for Interact Switch
Description
This is a wobble top for the Interact Switch (https://www.thingiverse.com/thing:4570894) Unlike the other caps, this one must be printed in two parts. That's because the tall top part must be printed with a flexible filament. This way if someone were to fall on it, it would safely bend out of the way. It will also prevent more extreme forces from being applied to the other parts of the switch during use. WobbleBottom: Regular filament WobbleTop: Flexible filament To connect the two, I have used contact cement, following the directions on the bottle. It's the stuff you brush on both sides, allow to dry for ~ 5 minutes, then press them together to form a permanent bond.
Statistics
Likes
0
Downloads
0