Z-Offset Test
Description
Prints a series of circles 1 layer (2mm) tall at z-offset from 0 to 0.22 mm above the build plate, in 0.02mm increments, to help dial in z offset. I set this up to help get rid of my elephant foot on prints. The Ender 3 Pro allows you to adjust z-offset by 0.1mm. I used a combination of changing that and the Cura Z-offset plugin to adjust my z offset 0.16mm (0.1mm on printer & 0.06mm in Cura). I printed this, found the first circle that wasn't easily knocked off the bed before it cooled and looked decent, and adjusted the offset, then printed another test cube.
Statistics
Likes
1
Downloads
0