15mm Tube connectors
Description
3 files, 3 parts 1- 80 Degree elbow connector 2- 80 Degree base (lower) 3- 90 Degree base (upper) Inner diameter is 15mm (I had some aluminium pipes laying around from old pop up displays) Print 2 of each, after cleaning use a heat gun at a low setting to soften the parts so you can insert the pipes. If you don't have a heat gun a hairdryer will do. Be safe. This was done for a Eryone Thinker SE but should work for others since you need to cut the pipes. I used white PLA (leftovers) at a 0.2mm layer height and 20% infill. Print using Tree Supports for easy removal.
Statistics
Likes
2
Downloads
0