Niceboy Vega+ holder
Description
Slide-in holder for Niceboy Vega+ camera to be mounted as a dashboard camera in car. I have measured the size and button location by hand, so it might be slightly off. If you have an idea to upgrade the model, just let me know. **Printing** The design expects printing “front face down”. The orientation of STL is already prepared. Supports are mainly not needed, there is only one part, where bridging will be used. During my test prints, I experimented with supports, but final print was without them and it works OK. It realy depends on your printer and how much confidence you have for you bridges. Just small support in the middle should be enough. Backlink to PrusaPrinters: https://www.prusaprinters.org/prints/59301-niceboy-vega-holder
Statistics
Likes
3
Downloads
0