Ender 3v2 Side Mount Spool Holder Extended
Description
The side mount for the spoolholder found on https://www.thingiverse.com/thing:3274902 was too short for my ender 3v2 to keep it free from the Z-axis stepper motor. So I adjusted this mount. 3 alterations: - I extended the middle section so now it clears the filament spool from the side of the printer and the filament can get straight into the extruder. No filament holder necessary. - I adjusted the attachment to the printer so it can slide into a 40x40. No nuts required for assembly to the printer. Just remove the cap from the 40x40 on the left backside of the printer and slide the mount onto it. - The holes in the mount where the metal spoolholder must be attached are not completely open. This makes it possible to mount the metal spoolholder to this extenden plastic mount with some screws (I did not have bolds). If you want to use bolds simply drill the holes through.
Statistics
Likes
13
Downloads
0