Anycubic 4MAX PRO X CARRIAGE E3D Dragon BMG DUAL DRIVE LM8UU ! 3DTOUCH !
Description
I would like to share with You my upgrade kit for 4MAX PRO. But be aware of that I have redesigned whole carriage connections and it is not stock tape friendly. You have to take care of that on Your own ;) but stock mount should fit as well for connection board. All parts are designed by me and are working fine on my printer. The idea was to develop a better E3D+Dual Gear carriage, with possibility to mount BLTouch/3D Touch sensor (Offsets to update in Marlin: X=-26.7mm, Y=0.5mm, Z=-1.42mm) Nozzle is in the exact same spot as a stock nozzle was placed - so there is no need to adjust Z stop sensor. You have to reverse X motor wiring, because belt mount has change. With this carriage, now I'm able to 'see' what is printing, which on default was truly difficult. In carriage are slots for M3 nuts - do not print supports inside ;) just put m3 nut inside. Extruder tension screw have to be replaced for longer one and You have to find out how to lock spring in place. i just printed for that M3 thin sleeve. X printing area should be bigger for about 8mm and Y less for about 6mm. Do not use this hotend duct without silicone sock on heatblock ;) BOM + non printable parts: > Carriage: >>1x Main Body - print ABS >>1x Nozzle Fan Duct - print ABS >>1x Radiator Fan Duct - print ABS >>2x GT2 Belt lock >> 4x LM8U MISUMI linear bearing - or the similar - 24mm >> 7x M3 NUT >> 6x M3 8mm screw >> 2x M3 20mm screw >> 2x M3 45mm screw >> a few M3 bolt washers >> 1x E3D/Dragon+Dual Gear+Heater+Thermistor, - from Trianglelab >> 1x Pancake motor - from Triangle lab - not required, stock is working as well >> 2x 5015 SUNON FANs MF50151VX >> 3DTouch sensor - not required > Y stopper: >> 2x Y stopper - print ABS Parts - for cable connection are not attached - because those are highly customized to my printer ;) All parts are printed from ABS - i have printed if with 100% fulfill but 50% should be ok too. Enjoy!
Statistics
Likes
18
Downloads
0