CR-10/CR-10S Creality RGBW cablemod light strip mount
Description
This should fit on any 20mm thick aluminum extrusion but it was designed to work on the cr-10 without interfering with dual z rods. THIS ISNT TESTED ON AN ENDER but it will probably interfere with a dual z mod on an ender since the spacing is so much closer. However, since the x carriage isn't as common of a mod on the ender, it should work Most of that sentence made sense... The slots for the strips are 16mm wide which was more than enough for my extra wide cable mod RGBW strips. Print with PETG or abs because PLA will eventually sag over months of weight being placed on them this will need to be printed in two pieces if you use an ender
Statistics
Likes
1
Downloads
0