FlashForge Dreamer Short Fan Filament Guide Clip
Description
#Flashforge Dreamer Short Fan Filament Guide Clip These Are Used To Clip The Filament Guide Tubes Onto The Fans On The Back Of The Dreamer. There Are 2 Clips: A And B. Both A And B Are Used On The Right And Left Fan. Take A Look At The Photo To See The Proper Positioning For The Clips On The Fans. My Dreamer Is The Older Model With A Foggy Door That Did Not Include Fans On The Back. I Added 4 Of My Own 80X80X15Mm Fans On The Back And Sides (See Http://Www.Thingiverse.Com/Thing:667612) Of My Dreamer For Added Cooling. Once I Did That, My Original Filament Guide Tube Clips No Longer Fit On The Back. So I Had To Create These New Shorter Filament Guide Tube Clamps. They Work Well. Note: I Am Powering My 4 Custom Added Fans Using The Extra Power Terminals Inside My Flashforge Dreamer'S Power Supply. They Are Attached To A Switch And Thermostat I Also Added So That I Can Manually Turn Them On Or Have My Thermostat Turn Them On Automatically. The Power Supply My Dreamer Came With Supplies Enough Power To Run 4 Additional 80X80X15Mm Fans, 4 Additional Short 24 Volt Led Light Strips, And A Thermostat! Pretty Sweet! ##See Also [Flashforge Dreamer Thermostat Mount](Http://Www.Thingiverse.Com/Thing:682667) Found Here: Http://Www.Thingiverse.Com/Thing:682667 [Flashforge Dreamer Side Panel Fan Mount](Http://Www.Thingiverse.Com/Thing:667612) Found Here: Http://Www.Thingiverse.Com/Thing:667612
Statistics
Likes
41
Downloads
0