12v Hammock light - Transparent filament. (untested)

Description

- A Switch Body And Led Strip Light Holder For 1 Section Of 10Mm Wide Self-Adhesive Cob Led Stripping (Trim To Length Type) - Note!!!: Intended For Transparent Pla/Abs! - These Are Designed To Work In Conjunction With My Flashlight/Battery Pack Design: Http://Www.Thingiverse.Com/Thing:639531 - Tested And Works Ok, But Some Tweaks To The Switch Body Are Coming.. ----------------------------------- The General Concept Is To Print Two Switch Halves, And Insert A Small Spst Toggle Switch (As Found On Ebay Or In Jaycar Stores). Use 3Mm Screws To Hold The Shell Together, And Wire Inline, This Should Then Be Hung From The Ridgeline Of Your Hammock. The Light Diffuser Is More Simple, Simply Wire A Single 50Mm Section Of Trim-To-Length, 10Mm Wide Led Stripping To Some Small Gauge Figure-Eight Cable, And Insert Face-Down Into The Diffuser - Secure With A Little Hot Glue. The Switch - Of Course Should Be Connected To The Same Wire The Light Is On... For Obvious Reasons. If You Need A Hanging 12V Battery Pack - I'M Developing One At The Above Mentioned Thingiverse Project. ----------------------------

Statistics

Category

Tags