Trampa mudguards
Description
Mud guards for Trampa trucks. These fit the infinity trucks with no motors or the spurgear motor brackets. They might fit the belt drive brackets if the hole spaces are in the same place but i haven't checked this. Best printed in TPU as I've found PETG and PLA too brittle and break within a few days. Rear wheel mudguard needs 4* M4 washers and reuses the original bolts. Its best to use Loctite on these and not tighten them too much or you'll distort the mudguard and it can rub on the tyre Front mudguards need a jubilee clip/hose clamp to attach (at least 30mm diameter) You might get away with large cable ties pulled very tight. I haven't tested V1.2 of the front guard as I'm waiting for more filament to arrive but I changed a few things which were meant stiffen it up a bit and extended slightly as i found some water was still being sprayed up. No supports needed. Remember to mirror one of each guard. 90~120g per wheel depending on slicer settings UPDATE: corrected wrong angle for the V1.2 front mudguard and added a slight extension for V1.3
Statistics
Likes
3
Downloads
0