Carbon and Silica Air Conditioner for Creality Resin Printers
Description
**Update: Found the hydrometer housing to be a little damaged so uploading a repaired one. This one is just a little bit thicker in some places so you will have to sand the upper housing just a little bit to accept the new hydro housing.** A simple mashup of a couple of designs inspirations and whatnot. With all the humidity lately, found it to be over 30%. I like to keep my printing environments less than 20%. So I had to rethink and rework some space to work in silica gel to remove any excess moisture. Hydrometer can be found cheaply on Amazon. 40mm I believe is the diameter of the meter. You can reuse the stock fan housing just placed upside down on top of the feet. The base recirculates the air inside the chamber to give it time to filter. Place as many 38~40mm cut activated carbon filters as you can in the lower housing. Top off the upper housing with silica gel. Pop in the hydrometer(you may want to remove the "clip" retainers to give more room for fitment). After screwing in the fan/fan housing/base/feet to the printer, everything else just slides and pops on together. References Used: https://www.thingiverse.com/thing:4508179 https://www.thingiverse.com/thing:4752529
Statistics
Likes
3
Downloads
0