Naked GoPro 6\7 LCD Touchscreen Case
Description
###Handy GoPro Hero 6 and 7 LCD touchscreen snap fit design for the BetaFPV Case V2. Update 2021-03-14: Added version 1.1 with 4 M2x5 screw holes on both plates for easier assembling. ### Installation: - De-case the back LCD touchscreen of your GoPro Hero 6 or 7. Remove the aluminum back plate too. Don't know how? Check out this tut https://youtu.be/watch?v=MNsSm-P9y5w - Place the screen on the Top Plate and route both ribbon cables through the hole. Just push the screen gently to fit the plate. You shouldn't need to use glue or tape. - Use thin double-sided tape (I use thermal tape) and apply it in both small rectangles visible on the Bottom Plate. - Route the ribbon cables through the hole of the Bottom Plate and tape both ribbon ends to the double-sided tape. Both ends need to fit the spacer so the connectors match the GoPro's PCB board. - Test the fit and make sure the screen powers on and the touchscreen is responsive - Put both plates together (use 4 M2x5 screws if using v1.1) - Enjoy! The trick is all about using the alignments correctly and this case should snap-fit with little effort. Don't force the connectors else you will damage them. Re-align the ribbon cable ends and retry. Print with a solid filament like PLA, PETG or ABS. Inspired by [thing:4648792](https://www.thingiverse.com/thing:4648792) and [thing:4648792](https://www.thingiverse.com/thing:4628273)
Statistics
Likes
74
Downloads
0