2020 Extrusion Bowden Tube Holder
Description
This is a small holder for a bowden tube of my Ender 5 Pro. I switched over to direct drive and was not satisfied with how the filament gets inserted into the Extruder, sliding on the sides of my printer frame which could possibly cause a failure of my gantry. The holder takes a 9.5mm tube fitting that came with my printer into the main hole on the top and screws into the 2020 extrusion using 2x M4x6 Screws and T-nuts. I attached my design file in FreeCAD so you can adjust it to your needs.
Statistics
Likes
7
Downloads
0