MT2 Collet Wall Holders
Description
MT2 wall mount Collet holders Someone asked if i could make a MT2 version of the R8 collet holder wall mounts, i don't own any MT2 collets, but i have a couple of MT2 bits for my mini lathe, so i modeled these using the (manky) dead centre i have. The hole is the proper MT2 taper (1.4307 degrees) and these should hold the collets in a good position, with enough sticking out to grab hold of (can always push them up from underneath too) I made them with the text 1mm to 12mm, and i've included a blank one that you can put stickers on if you use that weird imperial measurement system :) Also made one with no mounting holes in the back, so if you are mounting them on pegboard you can drill holes to match, and use a label printer to make text stickers for the sizes. The holders interlock with other ones i have made, and are based on these ER32 collet holders : https://www.thingiverse.com/thing:3588076 The screws i use to mount these to the wall are called 'Flange Head Self Tapping Screws'
Statistics
Likes
2
Downloads
0