Elektron stand high (65 degree angle)
Description
Stand for Elektron machines. 65 degree angle. 9,6mm thick Has a 30mm space between table surface and unit (good for running cables under if you have a device infront) Comes in three versions. See photos. Important to note: 1. Recommended screws; M3x10 (M3x12 is fine too). Longer screws risk damaging the PCB inside the unit. 2. Not recommended for ANALOG4, as this print doesn't have vent exhaust hole 3. Not for ANALOG4 MK2 or RYTM MK2, as those units have a different form factor
Statistics
Likes
5
Downloads
0