NanoMini (For Nerf NanoFire)
Description
Uses only 1.75mm Filament as hardware, the NanoMag platform started out just as a way to take advantage of the nub at the end of the Nerf NanoFire. It eventually expanded into a magazine system not shown here, this is the shortened version of it that I am providing for free. This takes the NanoFire barrel coupler, the rear rail system, and any front end that were developed for the NanoMag and provides a way to use them without adding the magazine system of the NanoMag. Only the "Basic" front end is provided. More front end STLs are provided via Etsy: https://www.etsy.com/listing/966073544/nanomag-files-digital-stlssteps Completed Prints of the NanoMini, with more front-end options, are available via Etsy: https://www.etsy.com/listing/965317552/print-to-order-nanomini-for-nerf # Blaster Required: Nerf NanoFire https://nerf.fandom.com/wiki/NanoFire -OR- Nerf Alpha Strike Stinger https://nerf.fandom.com/wiki/Stinger_SD-1 # Hardware Required Didn't you read above? No hardware needed, this is all 3D-printed! Just use wire cutters to cut out the following lengths of 1.75mm filament: *(All the part numbers below are prefixed with "`a2p`" for the filenames, e.g. the coupler has a filename of `a2p4.1_....stl`)* - 1x 7mm for Flip Up Sight (`7.2c`) - 3x 16mm for connecting Coupler (`4.1`) and Rear Rail (`5.1a`) to Adapter (`1.2`) - 1x 23mm for connecting Front End (`7.*`) to Adapter (`1.2`) - 2x 24mm for connecting Rear Sight (`6`) to Rear Rail (`5.1a`) - 3x 32mm for connecting Coupler (`4.1`) and Front End (`7.*`) to Adapter (`1.2`) - 1x 56mm for connecting Rear Rail (`5.1a`) to Rail Clip (`5.1b`)
Statistics
Likes
1
Downloads
0