Adafruit Feather - Wearable Case
Description
This case was originally made for a wearable motion capture system based on Adafruit HUZZAH32 and a 9-DoF IMU device. However, it supports most of Adafruit Feather boards. This case requires: - Two M2.5 nuts and two 2,5*8 screws. - Male/Female Short Headers for Feather boards (https://www.adafruit.com/product/2940 and https://www.adafruit.com/product/3002) - Adafruit's Breadboard-friendly SPDT Slide Switch (https://www.adafruit.com/product/805) - 200-400x20 mm Strap (e.g. Velcro strap - https://www.amazon.es/gp/product/B07WQ2RJ74/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1) Also, the original device includes: - Adafruit HUZZAH32 Feather board (https://www.adafruit.com/product/3405) - Adafruit 9-DOF Absolute Orientation IMU Fusion Breakout (https://www.adafruit.com/product/2472) - 3.7V 350 mAh battery (https://www.adafruit.com/product/2750) If the HUZZAH32 Feather and 9-DoF FeatherWing boards are used, solder the slide switch to the pads of the 9-DoF board connected to "EN" and "GND" pins of the HUZZAH32 board.
Statistics
Likes
6
Downloads
0