Ender 6 additions ventring, cablepipe holders and coolerfansupport
Description
These parts are made for the ender 6. The cable pipe, or tube needs a little bit more support than Creality had in mind to my humble opinion. There are 2 types, one that fits the Hotend carriage and the other can be bolted on to the frame. 20-march-2021 changed the framepart a little, made it internal wider from 15.5 to 16mm The Cooler fan support plate wil help preventing breaking off the fan eyelets. When fixing your coolerfan the fanhouse and eyelets are made flush to put on the hotend enclosure. The ventilation ring is a remix of https://www.thingiverse.com/thing:2912394 (JoeS21) and this one https://www.thingiverse.com/thing:4753106 (Fillboyt). I made the part from JoeS21 a little bit flatter and added a small angle between the ring and the upright part, so that it has more tendency to stay up during the use. I made this ring from ASA that can handle higher temperatures. All the other parts can be made out of PLA. 20-march-2021 Added a filamentguide, this is ment to use when you replace the extruder. You can slide it under the blue corner. The extruder used two T-nuts and M4 allenscrew to bolt this to the frame. This guide is a remix of https://www.thingiverse.com/thing:4779023 by Snebgard
Statistics
Likes
13
Downloads
0