Magnetic Modular Paint Rack Station
Description
##Credit I altered the 90 degree corners of this thing and created some new pieces for this setup. Credit to https://www.thingiverse.com/thing:1000772 for original idea. ##Description I added magnet holes for 2 6mmx2mm magnets that just help keep the pieces aligned on your desk. They're made with some tolerance (0.25mm) for my sloppy printer. Anything with _mix in the name is a dual hole for vallejo/citadel 3/25/2021 - I think I've perfected the holes that I personally want, they fit citadel on a top layer and vallejo on the bottom with a cut out so it uses less filament and you can view the paint a little bit. Nothing can tip if bumped either. These are the _recreated models. Still working my way through recreating my tools stand any anything else I might want. If you want dual purpose holes, download the _recreated models. These models have a 1mm larger top level so the magnet hole is off by 0.5mm but everything still can go together just fine in my experience (if you want to mix the other models with these ones). If you want the hole sizes for your own ideas: 33mm for citadel at 8.5mm deep 25.75mm for vallejo/reaper/armypainter at 11-13mm deep ##Settings Print using a thin wide brim so the edges don't lift. I'm getting away with 18% infill on a 0.6mm nozzle. first layer: 0.12mm other layers: 0.22mm brim count: 8 walls: 4 nozzle: 0.4-0.6mm (more than 0.6 might not make some of the smaller edges) top/bottom: 3mm 5 layers or so
Statistics
Likes
271
Downloads
0