TUSH V-Ring Mod (minimal change)
Description
The original TUSH is an absolute minimalistic masterpiece but I had an issue with grinding of the spool against the sides of TUSH. To fix this, I enlarged the whole upper portion with carriers for the bearings upwards by about 3mm to support 608/zz608-bearings with a press fitted V-ring for spool centering. To support TUSH at a spool width of around 58mm (running center to running center), there is also a spacer incuded in the parts. ___ *Parts list for full setup:* - 4x TUSH Mod - 4x V-ring from this: https://www.thingiverse.com/thing:3052488 - 2x TUSH Spacer 58mm *Optional:* - CA glue ___ *Assembly Instructions for one side (step 3 is optional):* 1. Fit a V-ring flush onto a 608 bearing, repeat this for one more bearing. 2. Take 1 TUSH Mod piece and set both V-ring fitted 608 bearings in place. 3. Put a small (!!!) drop of CA glue on each of the TUSH Mod surfaces inside the two bearings. 4. Take a second TUSH Mod piece and press it on. Have fun and please also leave a like at the original things: https://www.thingiverse.com/thing:2047554 https://www.thingiverse.com/thing:3052488
Statistics
Likes
15
Downloads
0