Ender 3v2 LCD Mount "PERFECTO"
Description
This is exactly what your Ender 3v2 should have been shipped with. It's PERFECTO! Slim down your printer's profile. I squeezed every bit of clearance that I could out of the screen's mount so that it would not interfere with any aftermarket hotend assemblies. This snazzy screen mount has 15 degrees of tilt and I must say, it looks damn good on the printer. Slides in easy and locks in to place with an M4 screw; the screw hole is pre-threaded for M4. Prints at .2mm layer height and can use various M4 screw lengths (I used a 10mm but you an go shorter or longer) Please note: your printer must be dialed in to compensate for holes being printed smaller than they are in the STL. The slot in this STL is 6.4mm wide. After setting my "Hole Horizontal Expansion" in Cura to 0.2mm, my printed part came out to a slot width of 6.2mm - which fits fine. If you have fitment issues, make sure your printer is printing this slot at a width of 6.2-6.4mm.
Statistics
Likes
157
Downloads
0