Hemera Mount - bottom with supports
Description
Found the original bottom part was too flexible and had a weak point at the leading edge. Remixed to strengthen below the mount as above is the vent for the cooling fan. Printed in PETg as PLA is too tight on igus bearings and binds. Make sure your printer is well calibrated first. Print slow, @25mm/s Printed at 50% infil. 0.2 resolution. When slicing add mouse ears to the "C" areas else likely you'll get warping - or use a really wide brim. Mouse ears worked well for me.
Statistics
Likes
0
Downloads
0