Biqu H2 Mount CR10-S Pro v2
Description
This is a mount to put the Biqu H2 extruder on the Creality CR10-S Pro v2. I do not know if this will fit the V1 printer but suspect that it should. Important: Replace the two m5 x 8 cap screws that attach the x-axis 2020 rail on the right side with button head screws to allow clearance for the backplate as I did not want to make the extrusion any thicker than necessary. Insert two m3 hex nuts into the back of the mount for the BlTouch bracket. Use m3 x 8mm socket head cap screws inserted through the back of the mount to attach the extruder. Attach the BlTouch bracket from the front of the mount using m3 x 8mm screws. I used button head screws. Attach the mount to the backplate using the top two screws for the x-axis rollers. Attach the BlTouch to the bracket. I reused the old screws that held it to the stock aluminum bracket. BlTouch offsets: X -43.4, Y -2.3 Update: I added another BlTouch bracket called BltTouch1mmUp.stl to raise the sensor up 1mm if you use the all metal hot end as it is shorter than the stock hot end. This was done in PLA except for the duct which was done with PETG. I used the fan duct from fhogphil https://www.thingiverse.com/thing:4789656 I would very much enjoy seeing a picture of everyone’s make.
Statistics
Likes
38
Downloads
0