Warsley/Ankey "clamp" holder table
Description
This is plate/table for https://www.thingiverse.com/thing:4702321 Labels are in milimeters from center hole axis. "adjusting_knob" thread is M16 You need to glue "washer_stopper" in place. And you will need to make clearance washer. You have to cut off "support layer" in "plate" with knife. You will need to print: 4pcs "10mm_nut" 2pcs "ledge" 2pcs "pullrod" and just 1pc of every other model Hardware you will need: 4pcs M6x20mm with 10mm head (minimum length is 16mm) 2pcs M6x60mm with 10mm head (minimum length is 55mm) 4pcs M4x15mm countersunk head screw/bolt 2pcs M6 nuts with 10mm head 6pcs M4 nuts with 7mm head 2pcs M4x15mm imbus You need to figure out how to assembly this thing :) I hope you like it, please leave a comment if you have any suggestions. Use PLA cause it is more stiffer than other materials. I can't figure out better way to make mounting rod(16x16x88_rod), if you have some suggestions please leave a comment.
Statistics
Likes
5
Downloads
0