GE Potbellly 9C Percolator Funnel
Description
A percolator funnel for filling a GE Potbelly 9 cup coffee basket without spilling all over. It works with a percolator wrap filter and allows for setting the basket on a scale if needed. It sets low enough into the basket to cover the stem hole and lifts up when the stem is inserted, minimizing the smaller grounds falling in. Not my actual pot, and the funnel is the first print with its myriad of errors. I really liked ThinkAndPrint's funnel, just to small so I put it on TinkerCad and resized until it fit. Several prints later and a few rounds with TinkerCad and I am happy with it. I think resizing it made the walls thicker too so it is sturdy, not that it needs to be. My walls are at three, there is an inner and outer wall and no space between. You can adjust the wall thickness, or infill as desired. I did print this funnel wide end up, with a brim, but no supports. So maybe yes maybe no on raft, but might suggest a brim due to its height and width, just to make sure.
Statistics
Likes
0
Downloads
0