GhiaJake's Resin Shrinkage Calibration Test
Description
This set of calibration tests is designed to figure out the percentage of shrinkage with different resins, or to figure out if your printer settings are off (like mine were, see below). There are 4 tests available; XYZ, X, Y, and Z. There are 11 calibration cubes for each Axis, ranging from 5mm to 5.5mm in increments of 0.05mm, which are all attached to a 0.2mm base. Set your layer height to 0.05mm, with 4 bottom layers. Set exposure times per your printer, and per the resin you're testing. Cubes should be measured with the numbers facing you, measuring from the face with the corresponding Axis letter to it's opposing face. You will need digital calipers. Again, see below before printing tests.
Statistics
Likes
2
Downloads
0