MPCNC LCD Enclosure
Description
Reprap LCD Enclosure, intended for an MPCNC or similar application, includes: - LCD Enclosure Faceplate - print face side down - LCD Enclosure Back (minor support for SD opening and bolt recess) - Stop Button - Dimmer hole Plug (optional) - Mounting Plate - Legs for Mounting Plate (basic, can be modified) - Dovetails are 120 degrees, 10mm at thin end by 7.5mm deep, undersize yours by .5mm for a very tight fit) - M3 washer / spacers Hardware recommended: - M3 x 8mm for LCD mounting - might need to clean up / drill / tap depending on your print tolerance - M4 x 30mm for Enclosure (recommend hex type) and running a drill bit through the back of the enclosure to make it a bit easier and tapping the faceplate. - 32mm (1.26 inch) round magnet, or any magnet that fits in the recess. You can add multiple magnets for additional holding force. OnShape design files are available in below link: https://cad.onshape.com/documents/5d1fd9060e0e2ed768f3cd42/w/d6e708bdd10a53a6a557e5c6/e/ab1fdd325375dcb6f545b9dd
Statistics
Likes
0
Downloads
0